APEC Water Systems WFS-1000 Manual de Utilização e Manutenção descarregar pdf

Fig. 10

FILTER CHANGE INSTRUCTIONS

How To Replace Stages 1, 2, 3 Filters:

1) Turn OFF cold water supply to system. Lift up faucet lever briefly to relief the built-up pressure

inside the system. This will make opening the housings easier.

2) Open housing: Have the System standing upright. Slip the plastic wrench onto the #1 housing.

Looking down from a top view, you should open the housing turning clockwise. If necessary, lay

System down on the floor to get a better leverage. If the housing is too tight, use a hammer and

tap on the wrench handle to help turn the wrench.

3) Discard 3 used filters, wash housings with mild soap, rinse off. Put 3 new filters into their respec-

tive housings: sediment filter in stage-1, carbon block filters in stages 2 & 3.

4) Close up the housings. Make sure each housing has a black O-ring in the thread groves. Use

wrench to tighten each housing.

5) Remember: Turn ON the cold water supply after finished changing filters!

6) Check for leaks!

Use

ench

3rd

Stage

2nd

Stage

1st

Stage

STEP 1

STEP 2

After taking the housing off, take out

the dirty filters and put the 3 new filters

in. Remember, Stage 2 and Stage 3 are

the same carbon filters.

Página 1

14Fig. 10FILTER CHANGE INSTRUCTIONSHow To Replace Stages 1, 2, 3 Filters:1) Turn OFF cold water supply to system. Lift up faucet lever briefly to re

Sem comentários

APEC Water Systems WFS-1000 Manual de Utilização e Manutenção